+IFC :0,0 - RTS/CTS turned off (hardware flow control)īoth modems are connected to a pc (for the testing), and communicate using AT commands entered into hyperterminal.ītw, when I call the modem with a phone, I get the same hyperterminal results as when using the modem. +SPEAKER :1 - Use speaker and microphone 1 +CMEE :1 - Mobile equipment error reports enabled
#Wath make the s5 go to autoanswer full#
V :1 - Transmits full headers and trailers and numeric result codes The gsm modem is a Wavecom WMod2 with a kpn simcard, with an activated datanumber (I've checked and had them test it) This modem has the following settings : S0=1 - Configures the modem to automatically answer the phone after 1 ring &Y1 - Sets break handling to destructive, expedited &U6 - Sets the minimum conenction speed to 9600bps &S0 - Data set ready override (always on) &N6 - Sets the maximum connection speed to 9600bps &M0 - Normal mode, error control disabled
#Wath make the s5 go to autoanswer serial#
&B0 - Sets modem serial port rate to variable, follows connection rate Q0 - Returns online/displays result codes L0 - Sets internal speaker to lowest volume (not used for external modem) The analogue modem is a US Robotics external 56 k modem, with the following settings : Can someone tell me what I'm doing wrong here? As far as I can tell both modems are configured correctly, I'm doing nothing wrong, but the connection is just not happening!
+WIND: 6,1 - Call was released, after NO CARRIERĪnd that's where it ends for me.The gsm modem detects an incoming voice message, and clears the call (hangs up). NO CARRIER - it hung up, at+ceer delivers error 16 : normal call clearing +CLIP: "+",145 - received call from (fax number used to dial in to the modem) +CRING: VOICE - Detects an incoming voice message, phone rings once The strange thing is, when I use the gsm modem to connect to the analogue, there are no problems, the connection is established, and data transfer is possible.īut when I use the analogue modem, and call my gsm's datanumber, the following debugoutput is generated (in hyperterminal) : I've done a few days worth of research to get this working, but I'm stumped! I'm having problems creating a connection between an analogue modem and a gsm modem.
0 kommentar(er)
